How to Apply Wallpaper to Textured Walls
Applying wallpaper to textured walls can be a challenging task, but with the right preparation and techniques, you can achieve a professional-looking finish. Whether you’re dealing with rough brick, stucco, or a textured paint finish, this guide will walk you through the process of how to apply wallpaper to textured walls.
Step 1: Prepare the Surface
Before you begin, it’s crucial to ensure that the textured wall surface is clean, dry, and smooth. Start by removing any loose debris, dust, or dirt. If the wall is painted, make sure the paint is in good condition and not peeling or flaking. If necessary, sand the textured surface to create a smoother base for the wallpaper.
Step 2: Prime the Wall
To ensure that the wallpaper adheres properly and lasts longer, it’s essential to prime the textured wall. Use a high-quality primer designed for wallpaper application. Apply the primer evenly, covering the entire surface. Allow it to dry completely before proceeding.
Step 3: Choose the Right Wallpaper
Selecting the right wallpaper is key to a successful application on textured walls. Opt for a wallpaper with a smooth finish, as it will be easier to apply and less likely to show imperfections. Additionally, consider the type of adhesive used on the wallpaper. Some wallpapers come with pre-pasted paper, while others require you to apply adhesive separately.
Step 4: Measure and Cut the Wallpaper
Measure the height and width of the wall area you want to cover. Add a few inches to each measurement to account for trimming. Cut the wallpaper accordingly, ensuring you have enough material to cover the entire surface. If you’re using a patterned wallpaper, take into account the pattern repeat and make sure the design aligns properly when cutting.
Step 5: Apply Adhesive to the Wall
Using a roller or a brush, apply a thin, even layer of wallpaper adhesive to the textured wall surface. Make sure to cover the entire area, including any corners or edges. Be cautious not to apply too much adhesive, as it can cause bubbling or peeling.
Step 6: Apply the Wallpaper
Starting from the top corner of the wall, gently apply the wallpaper to the adhesive. Use a smoothing tool to remove air bubbles and ensure a tight fit. Work from the center outwards, smoothing out any wrinkles or imperfections. Be patient and take your time to achieve a professional finish.
Step 7: Trim the Edges
Once the wallpaper has adhered to the wall, use a sharp utility knife or a wallpaper trimming tool to trim off any excess material at the edges. Be careful not to cut into the adhesive, as this can cause the wallpaper to peel.
Step 8: Clean Up
After the wallpaper has dried and set, clean up any adhesive residue from your tools and the floor. Wipe down the walls with a damp cloth to remove any smudges or dirt.
By following these steps, you’ll be able to successfully apply wallpaper to textured walls and create a stunning, cohesive look in your space. Remember to take your time and pay attention to detail for the best results.
