How to Install Bathtub Spout: A Step-by-Step Guide
Installing a new bathtub spout can breathe new life into your bathroom and improve the overall functionality of your bathtub. Whether you’re replacing an old, worn-out spout or upgrading to a new design, this step-by-step guide will help you install a bathtub spout like a pro. Let’s get started!
Step 1: Gather Your Tools and Materials
Before you begin, gather all the necessary tools and materials for the installation. You will need:
– New bathtub spout
– plumber’s tape
– plumber’s grease
– adjustable wrench
– screwdriver
– plumber’s putty
– a rag or paper towels
Step 2: Turn Off the Water Supply
To avoid any water damage or injury, it’s crucial to turn off the water supply to your bathtub. Locate the shut-off valves, typically located beneath the bathtub. Use an adjustable wrench to turn the valves clockwise until they are completely closed.
Step 3: Remove the Old Bathtub Spout
With the water supply turned off, you can now remove the old bathtub spout. Loosen the nuts that secure the spout to the bathtub using a screwdriver or adjustable wrench. Once the nuts are loose, carefully pull the spout out of the bathtub. If there is plumber’s putty or old plumber’s tape, remove it from the threads of the bathtub and the spout.
Step 4: Clean the Threads
Use a rag or paper towels to clean the threads of the bathtub and the new spout. This will help ensure a tight, leak-free connection when you install the new spout.
Step 5: Apply Plumber’s Tape and Grease
Wrap plumber’s tape around the threads of the bathtub where the spout will be installed. This will create a watertight seal. Then, apply plumber’s grease to the threads of the new spout. This will make it easier to install the spout and prevent it from sticking.
Step 6: Install the New Bathtub Spout
Insert the new bathtub spout into the bathtub, ensuring that the threads are aligned with the threads in the bathtub. Hand-tighten the nuts to secure the spout in place. Once the nuts are snug, use an adjustable wrench to tighten them further, but be careful not to overtighten, as this can damage the threads.
Step 7: Test for Leaks
Turn the water supply back on and check for leaks around the new bathtub spout. If you notice any leaks, turn off the water supply and tighten the nuts slightly. If the leaks persist, you may need to reapply plumber’s tape or grease and try again.
Step 8: Clean Up
After you’ve confirmed that there are no leaks, use a rag or paper towels to clean up any plumber’s tape, grease, or water that may have spilled during the installation process.
Congratulations! You’ve successfully installed a new bathtub spout. Enjoy your updated bathroom and the improved functionality of your bathtub.
