Step-by-Step Guide to Installing Bushwacker Fender Flares- A Comprehensive DIY Tutorial

How to Install Bushwacker Fender Flares

Installing Bushwacker fender flares can enhance the look of your vehicle and provide additional protection for your fenders. Whether you’re looking to customize your truck, SUV, or Jeep, these flares can make a significant impact. In this article, we’ll guide you through the process of installing Bushwacker fender flares on your vehicle. Follow these steps to ensure a successful installation.

Materials and Tools Needed:

Before starting the installation process, gather the following materials and tools:

– Bushwacker fender flares
– Ruler or measuring tape
– Socket set
– Screwdriver set
– Hammer
– Drill and drill bits
– Mounting brackets and hardware
– Caulk or sealant
– Safety glasses and gloves

Step 1: Measure and Mark the Installation Points

Begin by measuring the distance from the top of your fender to the desired height of the fender flares. Use a ruler or measuring tape for accuracy. Mark these points on your fender using a permanent marker or paint pen.

Step 2: Remove Existing Fender Flares (if applicable)

If your vehicle already has fender flares, remove them by loosening the screws or bolts holding them in place. Be sure to keep track of the hardware and store it safely.

Step 3: Attach the Mounting Brackets

Attach the mounting brackets to the fender flares using the provided hardware. Make sure the brackets are aligned with the marked points on your fender.

Step 4: Position the Fender Flares

Place the fender flares on your vehicle, aligning the mounting brackets with the marked points on your fender. Ensure that the flares are evenly spaced and properly positioned.

Step 5: Secure the Fender Flares

Using the provided hardware, secure the fender flares to your vehicle. Tighten the screws or bolts until they are snug but not overly tight. Be careful not to overtighten, as this may damage the fender flares or your vehicle’s fender.

Step 6: Caulk and Seal

Apply a layer of caulk or sealant around the edges of the fender flares to prevent water, dirt, and debris from entering the gap between the fender and the flare. Use a putty knife to smooth the caulk and ensure a proper seal.

Step 7: Clean Up and Final Adjustments

Wipe away any excess caulk or sealant with a damp cloth. Double-check the alignment and fit of the fender flares, making any necessary adjustments. Ensure that the flares are securely mounted and that there are no gaps or loose hardware.

Step 8: Install Trim (if applicable)

If your Bushwacker fender flares come with trim pieces, install them by following the manufacturer’s instructions. This will give your vehicle a finished, polished look.

Congratulations! You have successfully installed Bushwacker fender flares on your vehicle. Enjoy the enhanced appearance and added protection for your fenders.