How to Install Bump Fire Stock
Installing a bump fire stock on your firearm can significantly enhance your shooting experience by allowing for faster and more accurate follow-up shots. Bump fire stocks are designed to increase the rate of fire by allowing the stock to move back and forth rapidly with the recoil of the firearm. In this article, we will guide you through the process of installing a bump fire stock on your firearm safely and efficiently.
Before You Begin
Before you start the installation process, it’s essential to ensure that you have the following tools and materials:
– Bump fire stock
– Hex wrench or screwdriver
– Safety gear (goggles, gloves, and ear protection)
– Cleaning cloth
– firearm
Step 1: Prepare Your Firearm
1. Ensure your firearm is unloaded and clear of any ammunition.
2. Remove the magazine and any other accessories attached to the firearm.
3. Wipe down the firearm to remove any dirt or debris.
4. Put on your safety gear to protect yourself from any potential harm during the installation process.
Step 2: Remove the Existing Stock
1. Locate the screws holding the existing stock in place. Most firearms use hex screws, but some may use Phillips head screws.
2. Use the appropriate tool to remove the screws and set them aside.
3. Gently pull the stock away from the firearm, ensuring that no parts break or get lost during the process.
Step 3: Install the Bump Fire Stock
1. Take the bump fire stock and align it with the mounting points on the firearm.
2. Insert the screws into the mounting points and start tightening them by hand.
3. Use the hex wrench or screwdriver to tighten the screws securely. Ensure that the stock is snug and does not move when pressure is applied.
Step 4: Test the Bump Fire Stock
1. Reinsert the magazine into the firearm and load a few rounds.
2. Hold the firearm in a safe position and pull the trigger to test the bump fire stock’s functionality.
3. If the stock moves smoothly and the firearm operates as expected, you have successfully installed the bump fire stock.
Step 5: Finalize the Installation
1. Double-check the tightness of the screws to ensure the stock is secure.
2. Wipe down the firearm and the bump fire stock to remove any fingerprints or debris.
3. Store the firearm in a safe and secure location.
Conclusion
Installing a bump fire stock on your firearm can be a straightforward process when following the proper steps. Always prioritize safety and ensure that you have the necessary tools and knowledge before attempting the installation. With a properly installed bump fire stock, you can enjoy faster and more accurate shooting experiences.
